Tube fitting allows secure and repeatable meeting and dependable leak-free operations

ower administration company Eaton – now part of Danfoss Power Solutions (Sealing Technology, September 2021, page 2) – just lately expanded its product portfolio with the addition of the robust WALRINGplus delicate seal cutting ring system, optimised for thin-wall tubing.
Featuring a two-edge cutting ring, with additional soft sealing for both attainable leak paths, this tube fitting system allows straightforward, safe and repeatable assembly and reliable, leak-free operations.
It is designed to fulfill demanding requirements, involving hydraulic tube becoming in applications together with use in agriculture, building, commercial autos, discrete manufacturing, rail transportation and other industries.
It is suitable to be used with thin-walled tubes and, therefore, supports environment friendly weight and gas reduction of mobile machinery and moving parts of stationary machinery.
Correct meeting is crucial to tube becoming performance and WALRINGplus is designed to stop excessive or insufficient tightening. A clear block-stop perform supplies a tangible torque increase when the tip of an assembly is reached, so no torque or distance measurement is required.
In addition, a considerably lower force is required to tug the cutting ring over the tube – making assembly simpler, sooner and safer, while decreasing the danger of harm to the gentle seal. The O-ring groove position additionally permits frequent reassembly, without affecting efficiency.
To get เกจวัดแรงดันอากาศ of the risk of leaks that may create expensive injury and downtime, WALRINGplus additionally addresses their common root causes.
Soft sealing prevents leakages if: tubes or studs are slightly scratched, the fluid temperature fluctuates or the retention drive is lowered. Problems caused by low meeting torque additionally could be recognized earlier than the cutting ring is pulled from the tube – decreasing the danger of a catastrophic failure in software.
เกจวัดco2 -R7 machine further reduces meeting time and the effort required for WALRINGplus as nicely as the danger of leaks. By automating the method of cutting-ring meeting and tube-forming, this machine helps ensure optimum system efficiency while also reducing the required torque and rotrotation.
Specifications of WALRINGplus: • metal slicing ring with Viton O-rings; • for tube sizes 6–42 mm; • complies with ISO 8434-1; • excessive burst-pressure exceeding 4:1 security factor; • working stress up to 500 bar (L-series) and 800 bar (S-series); and • supports dry meeting with metal components.
Share

Leave a Comment